22

Use, maintenance and installation of sodium hyaluronate filling machine

Sodium hyaluronate, also known as sodium hyaluronate, is a polymer polysaccharide biomaterial. Sodium hyaluronate is the main component of joint fluid and one of the components of cartilage matrix. Injection of sodium hyaluronate can only relieve the pain symptoms, (treat the symptoms but not the root cause). For patients with knee osteoarthritis stage 3 and 4, try to apply sodium hyaluronate for 1-2 times, and if the symptoms do not improve, it should be treated as soon as possible. Follow the principle of step-by-step knee joint treatment for treatment, choose the corresponding knee-preserving surgery for treatment according to the pain site, deformity type (O-leg, X-leg), etc., and consider total knee arthroplasty at the end stage. the Use, maintenance and installation of sodium hyaluronate filling machine: the 1. Since this filling machine is an automatic machine, the sizes of the easy-to-pull bottles, bottle pads and bottle caps are all required to be uniform. the 2. Before driving, you must turn the machine with the crank handle to see if there is any abnormality in its rotation, and you can drive after confirming that it is normal. the 3. When adjusting the machine, the tools should be used properly. It is strictly forbidden to use too large tools or use too much force to remove parts so as not to damage the parts or affect the performance of the machine. the 4. Whenever the machine is adjusted, be sure to tighten the loose screws. Use the handle to turn the machine to check whether its action meets the requirements before driving. the 5. The machine must be kept clean. It is strictly forbidden to have oil, liquid medicine or glass chips on the machine, so as not to cause damage to the machine. Therefore, it is necessary to: the (1) During the production process of the machine, remove the liquid medicine or glass debris in time. the (2) Before shifting over, each part of the machine surface should be cleaned once, and clean lubricating oil should be added to each active part. the (3) It should be scrubbed once a week, especially the places that are not easy to clean in normal use or blown with compressed air. the After the sodium hyaluronate filling machine is installed, it is necessary to turn on the power and turn on the switch (be careful to stop immediately) to verify whether the running direction of the three-phase motor is correct, to ensure the pressure and flow of compressed air (0.4m3/min8bar) to check whether the motors and bearings are It is necessary to add lubricating oil (calcium-sodium-based butter), and it is strictly forbidden to run without oil. After checking that everything is normal, you can start the machine. At the same time, check whether the operating parts are normal, whether the fasteners are loose, and whether the parts are in good condition before they can be used normally.