How to maintain the gel filling machine?

The gel filling machine is equipped with a needle suitable for gel. The center of the lower surface of the filling needle is provided with a filling needle connected to it. The liquid inlet pipe is detachably connected with a connector. The outer casing is connected with the outer casing, and the lower part of the outer casing is provided with a rubber sealing sleeve. The length of the filling needle is twice that of the outer casing. The outer surface of the rubber sealing sleeve is a conical surface. The air pipe is provided with a sealing head, the upper end of the connector is provided with a rubber tube connector, one side of the connector is provided with an air inlet pipe, the inlet pipe communicates with the air filter through a pipe, and the other end of the air filter is connected with the air compressor. The air outlet is connected. The utility model has the following beneficial effects: strong practicability, a new type of 
Gel filling machine maintenance knowledge:

1. Synchronous maintenance method: In production, if a fault is found, please try not to repair it, and take a maintenance method to keep the production line running until the holiday, contact the maintenance personnel and operators, and repair all problems at the same time, the equipment is in the unified whole line Production.

2. Branch maintenance method: If there are major problems in the production line, the maintenance time will be longer, and the simultaneous repair method cannot be used. At this time, please use the holiday to concentrate on repairing a certain part by maintenance workers and operators.

3. Before the next holiday, please repair another part to ensure that the production line will not stop production during working hours. In addition, in the management, use the method before repairing as much as possible, install timers on the equipment, record the working hours of the equipment, and use Wear rules are used to predict the wear of wearing parts and replace wearing parts in advance, which can eliminate faults in advance and ensure the stable production of the filling machine assembly line.

Daily inspection of gel filling machine:

1. Check and clean the circuit, gas circuit, oil circuit and mechanical transmission parts (such as guide rail) before and after operation.

2. In the working process, spot check the key parts, find abnormalities, record them, and deal with minor problems before and after the shift (not long).

3. Unified shutdown and maintenance of automatic filling machine assembly line, formulation of wearing parts plan, replacement of wearing parts in advance, to prevent accidents.